Irregular Formatting in Parts
Posted: Sat Jul 01, 2017 1:04 am
Finale version 2014.5
I use both Mac and Windows, but prefer Windows.
Is there a shortcut to adjusting the space above just the odd numbered staves on my parts. I want my parts to have 10 staves per page with staves 1 and 2 close together, then a gap, then 3 and 4 close together, then a gap, then 5 and 6 close together, etc. Normally I would just drag them, but I will have 12 parts with about 50 pages each. So I could really use some advice.
I use both Mac and Windows, but prefer Windows.
Is there a shortcut to adjusting the space above just the odd numbered staves on my parts. I want my parts to have 10 staves per page with staves 1 and 2 close together, then a gap, then 3 and 4 close together, then a gap, then 5 and 6 close together, etc. Normally I would just drag them, but I will have 12 parts with about 50 pages each. So I could really use some advice.