Measures missing from extracted part
Posted: Fri Jan 20, 2017 4:49 am
I recently upgraded from Finale 2003a to Finale 25, so I'm still becoming accustomed to the new interface layout.
In attempting to extract a drum part from a big band chart, the extracted part is missing all of the measures in which I used a one-bar repeat staff style. For example: I fully notate one measure (like a simple time figure), followed by 7 bars of one-bar repeats. The extracted part does not show any of those 7 bars with the one-bar repeat sign. The measure numbers are still correct, but the part is missing measures where I used that staff style.I cannot figure out why this is happening.
I might also add that when I wrote a rhythm section chart using the setup wizard, no problems were encountered extracting the drum part, and the one-bar repeats showed in the part.
I am running Win10, 64-bit.
Any ideas why this is happening??
Alan Glasscock
In attempting to extract a drum part from a big band chart, the extracted part is missing all of the measures in which I used a one-bar repeat staff style. For example: I fully notate one measure (like a simple time figure), followed by 7 bars of one-bar repeats. The extracted part does not show any of those 7 bars with the one-bar repeat sign. The measure numbers are still correct, but the part is missing measures where I used that staff style.I cannot figure out why this is happening.
I might also add that when I wrote a rhythm section chart using the setup wizard, no problems were encountered extracting the drum part, and the one-bar repeats showed in the part.
I am running Win10, 64-bit.
Any ideas why this is happening??
Alan Glasscock