I just upgraded to v26.
I have my measure bars setup to where if I add a Double Barline in measure 3's right bar line, measure 4's left bar-line defaults to a double bar line.
I'm noticing there are no measure numbers on any measure where there's a double bar line on the left bar line.
I have checked ALL my options/prefs/settings and can't figure this out. Is this a new feature/setting within v26 that I'm unaware of? What am i missing?
here's a screenshot
https://imgur.com/a/WPm2MKE
Measure Numbers not showing on double bar lines
Moderators: Peter Thomsen, miker
- zuill
- Posts: 4418
- Joined: Sat Dec 10, 2016 9:35 pm
- Finale Version: Finale 2011-v26.3.1
- Operating System: Windows
From what I see in your picture, you have rehearsal markings at those bars. I think you are assuming it is the double bar line that is suppressing the measure numbers. It's actually the definition of the rehearsal mark expression, I believe. There is a checkbox to hide the measure number for that bar. Just uncheck that in the definition.
Zuill
Zuill
Windows 10, Finale 2011-v26.3.1
"When all is said and done, more is said than done."
"When all is said and done, more is said than done."
zuill wrote:From what I see in your picture, you have rehearsal markings at those bars. I think you are assuming it is the double bar line that is suppressing the measure numbers. It's actually the definition of the rehearsal mark expression, I believe. There is a checkbox to hide the measure number for that bar. Just uncheck that in the definition.
Zuill
Zuill...that did it!
I never used the Finale Auto-Sequenced rehearsal marks before v26 and didn't even know that was an option to hide measure numbers for that expression.
thanks a lot.
Finale v26, Digital Performer 9, ProTools 12. Mac.