Page 1 of 1

Problem with Repeat sign

Posted: Thu Oct 10, 2019 12:46 am
by sergiobn
Sometimes when I try to put a Repeat sign in a measure in a system with two lines for example, I see the correct repeat sign from top to bottom, but in the bottom measure appears a single line repeat superimposed, as shown in the attached figure. How an I avoid this?
repeat.jpg

Re: Problem with Repeat sign

Posted: Thu Oct 10, 2019 4:52 am
by zuill
What's happened here is that you have a Group that includes both staves, then another group that includes only the lower staff. Delete that group.

Zuill