Setting global mid-measure clef properties

General notation questions, including advanced notation, formatting, etc., go here.

Moderators: Peter Thomsen, miker

sPretzel
Posts: 48
Joined: Sun Mar 11, 2007 8:38 pm
Finale Version: Finale 2007
Operating System: Windows

Setting global mid-measure clef properties

Post by sPretzel » Fri Apr 16, 2021 1:13 pm

Hi,
In the Mid-Measure Clef dialogue box, there are a number of parameters one can set like clef size, horizontal/vertical offset, etc. In Document Options - Clefs however, there are only a few of these parameters to be set for the Default Clef Change. Is it possible, either before or after mid-measure clefs have been created, to set parameters in the mid-clef measure dialogue box for several (or for all) mid-measure clefs at once?
This is for Finale 2007c.
Thanks.

Re: Setting global mid-measure clef properties

by Sponsor

Forum Sponsor
 

User avatar
zuill
Posts: 4199
Joined: Sat Dec 10, 2016 9:35 pm
Finale Version: Finale 2011-v26.3.1
Operating System: Windows

Re: Setting global mid-measure clef properties

Post by zuill » Fri Apr 23, 2021 3:41 pm

I am using v26, so things might be different. The settings you mention are not in the dialogue box for Change Clef. They are only available after a changed clef is entered. So, I'm not sure that it would be practical to have those settings available as a default setting for Change Clef. I may be wrong. Once a clef is entered, it's position can be fine tuned with those number settings (H. and V.). Or, one can grab the handle and move the clef manually.

Zuill
Windows 10, Finale 2011-v26.3.1
"When all is said and done, more is said than done."

Post Reply