I would like to center measure numbers under multimeasure rests. The measure region feature works fine, except for the situation where the end of the multimeasure rest must be adjusted at a clef change. If I adjust the endpoint for the clef, the multimeasure rest count moves to be centered over the rest symbol, but the measure number range stays centered between the barlines.
What to do in this situation? I guess I could adjust the left side of the rest by the same amount. Or I could move the measure number range left, but there doesn't seem to be a way to type in an offset, and dragging with the mouse is imprecise.
Centering measure numbers under multimeasure rests
Moderators: Peter Thomsen, miker
- Shinohara 1027
- Posts: 32
- Joined: Sat Apr 22, 2023 3:08 pm
- Finale Version: Finale v27.4
- Operating System: Mac
deleted
Last edited by Shinohara 1027 on Sun Mar 17, 2024 1:48 pm, edited 1 time in total.
- Shinohara 1027
- Posts: 32
- Joined: Sat Apr 22, 2023 3:08 pm
- Finale Version: Finale v27.4
- Operating System: Mac
deleted
Last edited by Shinohara 1027 on Sun Mar 17, 2024 1:49 pm, edited 1 time in total.