General notation questions, including advanced notation, formatting, etc., go here.
Moderators: Peter Thomsen, miker
-
Al Fine
- Posts: 91
- Joined: Thu May 31, 2018 4:06 am
- Finale Version: Finale 25.2.0.79
- Operating System: Mac
Post
by Al Fine » Tue Jan 22, 2019 2:25 am
Greetings all. Often, after I make an entry in a measure while using the Speedy Entry Tool, if I then exit the measure, then immediately try to re-enter the same bar, it takes me several mouse clicks (7-10?) before the measure stays highlighted. This only started when I updated to my current version of Finale. Sooner or later, a click will put me into the editing mode, so it's not a big deal, but it is a bit of an annoyance.
Thanks.
-
motet
- Posts: 8296
- Joined: Tue Dec 06, 2016 8:33 pm
- Finale Version: 2014.5,2011,2005,27
- Operating System: Windows
Post
by motet » Tue Jan 22, 2019 3:14 am
Have you tried rebooting the computer?
-
Al Fine
- Posts: 91
- Joined: Thu May 31, 2018 4:06 am
- Finale Version: Finale 25.2.0.79
- Operating System: Mac
Post
by Al Fine » Tue Jan 22, 2019 3:26 am
Not after a specific occurrence of this problem, but my computer has been rebooted several times since this problem has been happening (over 2 years now, I think).
-
motet
- Posts: 8296
- Joined: Tue Dec 06, 2016 8:33 pm
- Finale Version: 2014.5,2011,2005,27
- Operating System: Windows
Post
by motet » Tue Jan 22, 2019 3:35 am
You might try recreating the preferences file and see if that helps.
-
Al Fine
- Posts: 91
- Joined: Thu May 31, 2018 4:06 am
- Finale Version: Finale 25.2.0.79
- Operating System: Mac
Post
by Al Fine » Tue Jan 22, 2019 4:09 am
What's odd, is that it isn't every single time. I wonder if I'm causing some sort of trigger each time it does happen. Hard to figure out the cause and effect, if there is one.