Problem with Repeat sign

General notation questions, including advanced notation, formatting, etc., go here.

Moderators: miker, Peter Thomsen

sergiobn
Posts: 24
Joined: Wed Jun 02, 2010 11:56 pm

Problem with Repeat sign

Post by sergiobn » Thu Oct 10, 2019 12:46 am

Sometimes when I try to put a Repeat sign in a measure in a system with two lines for example, I see the correct repeat sign from top to bottom, but in the bottom measure appears a single line repeat superimposed, as shown in the attached figure. How an I avoid this?
repeat.jpg
repeat.jpg (125.7 KiB) Viewed 70 times
Sergio Barrozo

Re: Problem with Repeat sign

by Sponsor

Forum Sponsor
 

User avatar
zuill
Posts: 2726
Joined: Sat Dec 10, 2016 9:35 pm
Finale Version: Finale 2011-v26.1
Operating System: Windows

Re: Problem with Repeat sign

Post by zuill » Thu Oct 10, 2019 4:52 am

What's happened here is that you have a Group that includes both staves, then another group that includes only the lower staff. Delete that group.

Zuill
Windows 7, Finale 2011-v26.1
"When all is said and done, more is said than done."

Post Reply